Filter
Top Products
33
TANDBERG CONTENT SERVER
USER GUIDE
Table of
Contents
What’s New in
this Version?
Trademark/
Licenses
Safety/
Environmental
Introduction Installation Quick Setup Operation
Administrator
Settings
Conference
Setup
View
Conferences
Appendices
D 13898.04
DECEMBER 2006
Fields with an orange asterisk next to
them require you to restart the service
in order for them to become effective if
they have been changed.
Gatekeeper
Administrator Settings > Site Settings
E.164 Gateway Prefix. Alias prefix if
registered as a Gateway.
Current Status. Displays the status
of Content Server registration with the
gatekeeper. (Registered or not registered).
Enabled. Choose Enabled to attempt
registration with the Gatekeeper.
Gatekeeper Discovery. Gatekeeper
Discovery configuration can be set to
MANUAL or AUTO.
Manual – The system will use a specific
gatekeeper identified by Gatekeeper IP
address.
Auto – The system will automatically try
to register on any available gatekeeper.
If a gatekeeper responds to the request
sent from the codec within 30 seconds
this specific gatekeeper will be used.
This requires auto discovery on the
gatekeeper as well. If no gatekeeper
responds, the system will not use a
gatekeeper for making H.323 calls and
hence an IP address must be specified
IP Address. This gatekeeper IP-address
will be used if you specify Gatekeeper
Discovery: Manual.
Port. This port setting should not be
changed unless the local network
configuration specifies a different port.
Registration. Choose to register the Content
Server as a Terminal or as a Gateway.
H.323 Gateway Prefix. Alias prefix if
registered as a Gateway.
Restart Service. Restart Service will terminate calls that are currently live (that is, the
calls will be ended and conferences will not be available for on demand playback).
Before restarting the Service, check if there are live conferences in progress in the
Live Conferences page or check the call status on the LCD panel of the unit. The Site
Settings page will also display a warning if calls are in progress. If you click on the
Restart Service button while calls are in progress, you will be asked to confirm if you
want to go ahead with the Restart.