Filter
Top Products
32
TANDBERG CONTENT SERVER
USER GUIDE
Table of
Contents
What’s New in
this Version?
Trademark/
Licenses
Safety/
Environmental
Introduction Installation Quick Setup Operation
Administrator
Settings
Conference
Setup
View
Conferences
Appendices
D 13898.04
DECEMBER 2006
NAT Address. The NAT address must be
the global, external address to a router
with NAT support. In the router, the
following ports must be routed to the
system’s IP address:
Port 1720
Port 2326–2365
The port range specified by the Port
Range field
Please contact your TANDBERG
representative or authorized reseller for
more information.
Use Static Ports is disabled by default.
This means that the system will
dynamically allocate which ports to use
when opening a TCP/UDP connection.
Static ports can be enabled by selecting
the checkbox and specifying the required
range of ports.
Advanced H.323 Settings
Administrator Settings > Site Settings
Port Range. 3230 to 3250 is the
standard firewall port range. It needs
to be configured according to your local
firewall settings.
NAT. Network Address Translation is used
when the Server is connected to a router
with NAT support. The default setting for
NAT is OFF.
If NAT is ON, the system will signal the
configured NAT address in place of its own
IP address within Q.931 and H.245.
If NAT is set to AUTO, the system will try
to determine whether the NAT address
or the real IP address should be used for
signaling. This is done to make it possible
to make calls to endpoints on the LAN as
well as WAN.
Fields with an orange asterisk next to them require
you to restart the service in order for them to become
effective if they have been changed.
Restart Service. Restart Service will terminate calls that are currently live (that is, the
calls will be ended and conferences will not be available for on demand playback).
Before restarting the Service, check if there are live conferences in progress in the
Live Conferences page or check the call status on the LCD panel of the unit. The Site
Settings page will also display a warning if calls are in progress. If you click on the
Restart Service button while calls are in progress, you will be asked to confirm if you
want to go ahead with the Restart.