Filter
Top Products
31
TANDBERG CONTENT SERVER
USER GUIDE
Table of
Contents
What’s New in
this Version?
Trademark/
Licenses
Safety/
Environmental
Introduction Installation Quick Setup Operation
Administrator
Settings
Conference
Setup
View
Conferences
Appendices
D 13898.04
DECEMBER 2006
Restart Service. Restart Service will terminate calls that are currently live (that is, the
calls will be ended and conferences will not be available for on demand playback).
Before restarting the Service, check if there are live conferences in progress in the
Live Conferences page or check the call status on the LCD panel of the unit. The Site
Settings page will also display a warning if calls are in progress. If you click on the
Restart Service button while calls are in progress, you will be asked to confirm if you
want to go ahead with the Restart.
Fields with an orange asterisk next to them require
you to restart the service in order for them to become
effective if they have been changed.
Content Server Properties
Administrator Settings > Site Settings
System Name. System Name. Other sys-
tems can call the Content Server using
the System Name, if the Content Server
is registered to the gatekeeper. The
Recording Alias specified in the Default
System Alias will be used for the call.
Other systems can also dial in using the
Content Server’s IP address (in this case,
the Content Server does not need to be
registered to the gatekeeper).
Content Library Host Name. The default
for the Content Server installation is
(local). It is recommended to leave the
Content Library Host Name in the Site
Settings as (local), unless instructed
otherwise by TANDBERG support.
H.323 Listen Port. Standard
videoconferencing port. Users only
need to change this setting if the local
videoconferencing port at customer site
is set to a different port.
H.323 Address. The default for the
Content Server installation is (local).
It is recommended to leave the H.323
address in the Site Settings as (local),
unless instructed otherwise by TANDBERG
support.
E.164 Alias. Other systems can call the
Content Server using the E.164 Alias, if
the Content Server is registered to the
gatekeeper. The Recording Alias specified
in the Default Recording Aliases will be
used for the call.