114 CHAPTER 6: IP SERVICES COMMANDS
Examples — To reset the NTP interval to the default value, type the
following command:
WX4400# clear ntp update-interval
success: change accepted.
See Also
■ “clear ntp server” on page 113
■ “display ntp” on page 125
■ “set ntp” on page 147
■ “set ntp server” on page 148
■ “set ntp update-interval” on page 149
clear snmp trap
receiver
Clears a single entry from the Simple Network Management Protocol
(SNMP) trap receiver table.
Syntax —
clear snmp trap receiver ip-addr
■ ip-addr — IP address of the trap receiver, in dotted decimal notation.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — To delete the trap receiver at IP address 192.168.0.1, type
the following command:
WX4400# clear snmp trap receiver 192.168.0.1
success: change accepted.
See Also
■ “set ip snmp server” on page 142
■ “set snmp community” on page 149
■ “set snmp trap” on page 150
■ “set snmp trap receiver” on page 153
