294 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
■ “set service-profile cipher-wep104” on page 301
■ “set service-profile cipher-wep40” on page 302
■ “set service-profile psk-phrase” on page 303
■ “set service-profile psk-raw” on page 304
■ “set service-profile rsn-ie” on page 305
■ “set service-profile shared-key-auth” on page 306
■ “set service-profile ssid-name” on page 307
■ “set service-profile ssid-type” on page 307
■ “set service-profile tkip-mc-time” on page 308
■ “set service-profile web-aaa-form” on page 308
■ “set service-profile wep active-multicast- index” on page 310
■ “set service-profile wep active-unicast- index” on page 311
■ “set service-profile wep key-index” on page 311
■ “set service-profile wpa-ie” on page 312
set radio-profile
short-retry
Changes the short retry threshold for the MAP radios in a radio profile.
The short retry threshold specifies the number of times a radio can send a
short unicast frame without receiving an acknowledgment.
Syntax —
set radio-profile name short-retry threshold
■ name — Radio profile name.
■ threshold — Number of times the radio can send the same short
unicast frame. You can enter a value from 1 through 15.
Defaults — The default short unicast retry threshold for MAP radios is 5
attempts.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command
.
