set {ap | dap} radio antennatype 265
See Also
■ “display {ap | dap} config” on page 234
set {ap | dap} radio
antennatype
Sets the external antenna model for a MAP that supports external
antennas.
Syntax —
set {ap port-list | dap dap-num} radio {1 | 2}
antennatype {ANT1060 | ANT1120 | ANT1180}
■ ap port-list — List of ports connected to the MAP access points on
which to set the channel.
■ dap dap-num — Number of a Distributed MAP on which to set the
channel.
■ radio 1 — Radio 1 of the MAP.
■ radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
■ antennatype {ANT1060 | ANT1120 | ANT1180} — External antenna
model:
■ ANT1060 — external directional antenna with 60° horizontal
beamwidth.
■ ANT1120 — external sectorized antenna with 120° horizontal
beamwidth.
■ ANT1180 — external sectorized antenna with 180° horizontal
beamwidth.
Defaults — The default antenna model is ANT1180.
Examples — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command applies only to MAP models MP-341, MP-352,
and MP-262.
Examples — The following command configures the 802.11b/g radio on
Distributed MAP 1 to use antenna model ANT1060:
WX4400# set dap 1 radio 1 antennatype ANT1060
success: change accepted.
