266 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
See Also
■ “display {ap | dap} config” on page 234
set {ap | dap} radio
auto-tune
max-power
Sets the maximum power that RF Auto-Tuning can set on a radio.
Syntax — set {ap port-list | dap dap-num } radio {1 | 2}
auto-tune max-power power-level
■ ap port-list — List of ports connected to the MAP access points on
which to set the channel.
■ dap dap-num — Number of a Distributed MAP on which to set the
channel.
■ radio 1 — Radio 1 of the MAP.
■ radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
■ power-level — Maximum power setting RF Auto-Tuning can assign
to the radio, expressed as the number of decibels in relation to 1
milliwatt (dBm). You can specify a value from 1 up to the maximum
value allowed for the country of operation.
The power-level can be a value from 1 to 20.
Defaults — The default maximum power setting that RF Auto-Tuning
can set on a radio is the highest setting allowed for the country of
operation or highest setting supported on the hardware, whichever is
lower.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command sets the maximum power that
RF Auto-Tuning can set on radio 1 on the MAP access point on port 6 to
12 dBm.
WX1200# set ap 6 radio 1 auto-tune max-power 12
success: change accepted.
See Also
■ “set {ap | dap} radio auto-tune max- retransmissions” on page 267
■ “set radio-profile auto-tune power-backoff- timer” on page 279
