3
SYSTEM SERVICE COMMANDS
Use system services commands to configure and monitor system
information for a WX switch.
Commands by
Usage
This chapter presents system services commands alphabetically. Use
Table 6 to located commands in this chapter based on their use.
Table 6 System Services Commands by Usage
Type Command
Display “clear banner motd” on page 38
set banner motd on page 46
display banner motd on page 40
set confirm on page 47
set length on page 48
System Identification set prompt on page 50
set system name on page 55
set system location on page 54
set system contact on page 51
set system countrycode on page 51
set system ip-address on page 53
display system on page 42
clear system on page 39
clear prompt on page 39
Help help on page 45
History history on page 46
clear history on page 38
