74 CHAPTER 4: PORT COMMANDS
■ For a WX4400, you can specify a number from 1 to 256.
■ For a WX1200, you can specify a number from 1 to 30.
■ serial-id serial-ID — MAP access point serial ID. The serial ID is
listed on the MAP case. To show the serial ID using the CLI, use the
display version details command.
The serial ID of the AP2750 might be preceded by 4 digits and a slash
(example: 0100/). Do not enter these digits or the slash.
■ model {ap2750 | mp-52 | mp-101 | mp-122 | mp-241 | mp-252 |
mp-262 | mp-341 | mp-352}
— MAP access point model:
■ ap2750 — Contains one radio that can be configured through
software for 802.11a or 802.11b/g.
■ mp-52 — Contains one 802.11a radio and one 802.11b radio,
with adjustable external antennas.
■ mp-101 — Contains one radio that can be configured through
software for 802.11a or 802.11b.
■ mp-122 — Contains one 802.11a radio and one 802.11b/g radio.
■ mp-241 — Contains one radio that can be configured through
software for 802.11a or 802.11b/g.
■ mp-252 — Contains one 802.11a radio and one 802.11b radio.
■ mp-262 — Contains one 802.11a radio and one 802.11b radio,
and a connector for an external antenna for the 802.11b/g radio.
■ mp-341 — Contains one radio that can be configured through
software for 802.11a or 802.11b/g, and a connector for an
external antenna for the 802.11b/g radio.
■ mp-352 — Contains one 802.11a radio and one 802.11b radio,
and a connector for an external antenna for the 802.11b/g radio.
■ radiotype 11a | 11b| 11g — Radio type:
■ 11a — 802.11a
■ 11b — 802.11b
■ 11g — 802.11g
This option applies only to single-radio models. The value 11g does
not apply to model MP-101.
Defaults — The default radio type for model MP-101 is 802.11b. The
default radio type for model AP2750, MP-241, and MP-341, and for the
