216 CHAPTER 7: AAA COMMANDS
The following command adds port 3 to the magnolia Mobility Profile
(which is already assigned to port 2):
WX1200# set mobility-profile name magnolia port 3
success: change accepted.
See Also
■ “clear mobility-profile” on page 176
■ “display mobility-profile” on page 185
■ “set mac-user attr” on page 207
■ “set mac-usergroup attr” on page 213
■ “set mobility-profile mode” on page 216
■ “set user attr” on page 218
■ “set usergroup” on page 219
set mobility-profile
mode
Enables or disables the Mobility Profile feature on the WX switch.
CAUTION: When the Mobility Profile feature is enabled, a user is denied
access if assigned a Mobility-Profile attribute in the local WX switch
database or RADIUS server when no Mobility Profile of that name exists
on the WX switch.
Syntax —
set mobility-profile mode {enable | disable}
■ enable — Enables the use of the Mobility Profile feature on the WX
switch.
■ disable — Specifies that all Mobility Profile attributes are ignored by
the WX switch.
Defaults — The Mobility Profile feature is disabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — To enable the use of the Mobility Profile feature, type the
following command:
WX1200# set mobility-profile mode enable
success: change accepted.
