420 CHAPTER 15: 802.1X MANAGEMENT COMMANDS
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — To reset the default timeout for requests to an
authentication server, type the following command:
WX4400# clear dot1x timeout auth-server
success: change accepted.
See Also
■ “display dot1x” on page 421
■ “set dot1x timeout auth-server” on page 431
clear dot1x timeout
supplicant
Resets to the default setting the number of seconds that must elapse
before the WX switch times out an authentication session with a
supplicant (client).
Syntax —
clear dot1x timeout supplicant
Defaults — The default for the authentication timeout sessions is
30 seconds.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — Type the following command to reset the timeout period
for an authentication session:
WX4400# clear dot1x timeout supplicant
success: change accepted.
See Also
■ “display dot1x” on page 421
■ “set dot1x timeout supplicant” on page 431
clear dot1x
tx-period
Resets to the default setting the number of seconds that must elapse
before the WX switch retransmits an EAP over LAN (EAPoL) packet.
Syntax —
clear dot1x tx-period
