Filter
Top Products
INTRODUCTION NAVIGATION RADIO MODE CD MODE INDEXSETUPCD CHANGER
12
Switching the unit on/off
1 To switch on the TravelPilot when the KeyCard is inserted, press the
blue button 2 in the centre of the volume control 3.
✔ The unit plays the audio source that was active last at the preset volume
level.
You can find out how to set the power-on volume in the section entitled “Config-
uring power-on / telephone / navigation / traffic information announcement vol-
ume and GALA settings” in the “Setup” chapter.
Switching on/off using the KeyCard
You can also switch the TravelPilot on/off by inserting and removing the Key-
Card.
Switching on when the vehicle ignition is off
You can also operate the TravelPilot when the ignition is off and the KeyCard is
inserted.
1 To do so, press the ON button 2.
✔ The unit switches on.
After an hour has elapsed, the unit switches off automatically in order to protect
the vehicle battery. You can repeat this procedure as often as you like. The
imposed time limit is cancelled as soon as the ignition is turned on.
Note: To ensure that the TravelPilot functions properly and that in-
creased power consumption is avoided, the unit must be connect-
ed to the continuous power source and the power source via the
ignition as described in the installation instructions.