Filter
Top Products
24
Before Using the Interactive Function
■ Setting the Electronic Pen
Marker for Interactive
Cap
Adaptor
Color
Identification Cap
Remove the
temporal cap.
3
1
2
2
Inserting
Pen Holder
Lever
Locking
Releasing
Marker for
Interactive
3
1
2
3
+
-
+
-
3
1
2
Battery
Cover
Pen Holder
1
Remove the battery cover on the pen holder,
insert the batteries as shown in the figure to
the right, and re-attach the battery cover.
CAlways use “AAA” size (alkaline) batteries and
be sure that their polarity is properly oriented.
CDo not mix old and new, different type batteries
when replacing batteries.
2 ~ 3mm (
3
/32" ~
4
/32" )
Remove the temporal cap, and set the cap and
adaptor to the marker for interactive.
CSecurely push the adaptor into the maker for
interactive as far as it will go.
CDo not remove the color identification cap on
the back end of the marker.
Rotate the pen holder lever to the release
position, insert the marker for interactive, and
then return the pen holder lever to the lock
position.
CLock the pen holder lever while inserting the
marker all the way into the pen holder until you
hear a buzzing sound.
Detection of the marker color may not work well
unless the marker is inserted fully into the pen
holder.
CDo not set the marker near the electronic print
board while using the interactive function as
this may appear unnecessary streaks not
written on the computer screen.
CPress down firmly with the point of the Electronic Pen on the screen film until you hear a buzzing sound.
CFor precise positioning, keep the Electronic Pen perpendicularly to the screen during use. Inclined pen angle will
cause the shift of position.
Note