Filter
Top Products
Help
9
Before you start
CMake thick and dark lines inside the copying
area. Note that any writing inside the
shaded area on the right figure cannot
be copied.
CUse a commercially available white board cleaner for hard-to-erase stains.
(SANFORD
®
EXPO
®
white board cleaner etc.)
CDo not erase with an overly dirty eraser. (See page 65.)
CDo not allow writing to remain on the screen for an extended period of time as it
will become harder to erase.
CPeriodically wipe the screen film gently with a water-dampened cloth that has
been thoroughly wrung. (See page 65.)
CDo not touch the screen, write with markers, or erase while the screen is moving
as this may result in damage to the unit.
Precautions
Installation
CDo not install the unit where it may be exposed to direct sunlight, near heating
equipment, or near air-conditioning vents as this may cause stretching and/or
discoloration of the screen.
CDo not install the unit in locations having a temperature of 10°C (50°F) or lower or
where the temperature may change suddenly as this may disable the unit’s ability
to make copies.
Screen film
Copying area
25mm (1")
25mm (1")
35mm
(1
3
/8")
35mm
(1
3
/8")
Markers,
Erasers and
Thermal
transfer film
CUse only the included or designated markers, erasers and thermal transfer film.
(See page 71.)
Use of accessories other than those included or designated (such as oil-based
markers) may damage the screen or result in hard-to-erase markings.
CCopy quality increases with the thickness of the drawn line. To ensure quality
copies, please use the markers (Big).
CThe markers for interactive (Small) draw thin lines. The quality of the copies may
be reduced when these markers are used.
CDo not store the thermal transfer film in a location subject to extreme changes in
temperature (such as near air conditioning or heating equipment) as this may
cause condensation on the thermal transfer film and result in poor print quality
and/or paper jams.
CStore markers horizontally as vertical storage may stop the ink from coming out.
CThe length of one roll of designated thermal transfer film (Replacement film : KX-
BP081 or KX-BP082) is approximately 100 meters (328.1'). One roll of thermal
transfer film can make approximately 300 sheets of copies.
Note that the total number of copies may differ depending on the operating
conditions.
Also note that the length of the thermal transfer film supplied with the unit is
shorter than the replacement film roll and is only approximately 20 meters (65.6').
SANFORD
®
and EXPO
®
are registered trademarks of Sanford corporation.