Filter
Top Products
30
Using the Interactive Panaboard Software
■ Pop-up menu configuration of the Interactive Panaboard Software
■ Switching the mode
Right-click the in the Taskbar to get the pop-up menu.
Following operations are possible in the pop-up menu.
Select Mode... : Allow you to switch between modes (Projector mode/ Whiteboard mode).
Calibrate : Execute the calibration. (Projector mode only) ➡ Page 33
Tool Draw : Display the Desktop Drawing Tool. (Projector mode only) ➡ Page 36
View Window : Display the View window. (Projector mode only) ➡ Page 42
Open/Close
Whiteboard window : Switch the Whiteboard window open/close. (Whiteboard mode only) ➡ Page 45
Settings COM Port... : Set the communication port.
Adjustment... : Adjust the position of the Electronic Pen or the Electronic Eraser to
improve the shifted position.
Options... : Set the option of the Interactive Panaboard Software.
Help Topics... : Display the help of the Interactive Panaboard Software.
About... : Display the Interactive Panaboard Software version information.
Exit : Exit the Interactive Panaboard Software.
You can freely switch the Projector mode and the Whiteboard mode while the
Interactive Panaboard Software is running.
■ Settings of the Interactive Panaboard Software
CCOM port
Setup the communication port to communicate with the Interactive Panaboard.
1
Right-click the icon in the Taskbar and click [Select Mode...] in
the pop-up menu. In addition, you can double-click the icon in
the Taskbar.
CThe Select Mode dialog box will appear.
(1) Right-click the icon in the Taskbar and click [Settings] · [COM
port...] in the pop-up menu.
CThe COM port dialog box will appear.
(2) Click the [Start...] button of the Auto Detection to detect the communication port
connected with the Interactive Panaboard automatically.
Otherwise, click the arrow at the bottom on the right side of the [COM port] box and then
click the communication port from the list.
(3) Click the [OK] button.
2
Click either the [Projector] button or the [Whiteboard] button, and then click the [OK] button.
CWhen switching to the Projector mode, the calibration screen will not be displayed automatically
after calibration ended correctly once. Please calibrate if necessary.
CWhen switching to the Whiteboard mode, the Whiteboard window will be displayed.