Filter
Top Products
76
Print Board Operations Check
After assembling the print board, perform the procedures presented in the following table to make sure it functions
properly.
■ Normal print board operations check
Step
Normal print board operations (points to check)
Multiple copy/
error display
Other points to check
1
Turn on the power switch.
" " flashes after
" " lights up.
2
Open the printer door and attach the supplied
thermal transfer film, then close the printer door.
CInstalling Thermal Transfer Film procedure
(refer to page 14)
" " flashes.
3
Open the paper cover and insert ordinary Letter
test paper, then close the paper cover.
CLoading Copy Paper procedure
(refer to page 16)
" " lights up.
4
Open the printer door.
" " flashes.
5
Close the printer door.
" " lights up.
6
Press .
CDoes the screen film surface
feed smoothly
?
CAre there any strange noises?
7
Use the supplied marker to draw a large
filling the entire copyable area of the
screen film surface.
CCopyable area (refer to page 9)
Press twice. (will add to 3 copies)
C""will be displayed.
Press .
" " lights up.
CAre three copies made?
CIs the entire readable area
printed?
CDuring the copying process, are
there any strange noises or
paper jams? Are multiple sheets
of paper fed through at the same
time?
8
Press to move the screen film surface.
Write letters, etc. with the marker.
Press once.
Press .
CHas the darkness indicator light
turned on?
CIs the image copied properly?
CAre there strange markings on
the copy sheet (e.g., stripes or
lines)?
9
Press once.
Has the darkness indicator light
turned off?
10
Press .
1 2
Are two screens copied properly?
BIf the unit fails on any of the check points, please contact your dealer.