Filter
Top Products
The daylight displayis used
even when the vehicle lights are
on.
[Day] isselected to [Day/Night Dis-
play].
Check [Day/Night Display] settingand make
sure [Automatic] is selected. (Page 50)
The orange/white leadis not con-
nected.
Check the connection.
The display is very dim. The vehicle’s lightis turned ON,and
[Automatic] is selected on [Day/
Night Display].
Read about[Day/Night Display] setting and,
if desired,select [Day]. (Page 50)
The vehiclecabin temperature is ex-
tremely low.
A LiquidC rystal Display (LCD)is used, and
such displays tendto darken whencold. Wait
for the vehicleto warm up.
Picturequality adjustment of the
display isnot correct.
Adjust the picturequality. (Page 153)
Display tilt isnot at theproper set-
ting.
Pressand hold EJECT buttonto adjust thetilt.
No sounds areheard.
The volume levelwill not rise.
The volume levelis low. Adjust the volumelevel.
The attenuator ormute is on. Turn the attenuator or mute off.
The speaker leadis disconnected. Check the connection.
The volumeof beeps andnaviga-
tion guidance cannotbe ad-
justed.
You cannot adjustthese parameters
with VOL(a/b) button.
Turn the volume up ordown with [Volume]in
[Settings]menu.
Adjusting the volumeof naviga-
tion guidance andbeeps is not
possible.
You cannot adjustthem with VOL
(a/b) button.
Turn thevolume up ordown according to[Vo-
lume]in[Settings] menu.(Page 88)
A strange soundis heard when
the vehicle comesclose to acer-
tain place (e.g.Dog barking).
The sound forthe entry of [Address
Book] is set.
Set thesound setting of that entry to [No
Sound]. (Page 63)
An alarm sounds when you ap-
proach theregistered location
and the setimage pops up,re-
gardless of whether[Address
Book Icon]is set to [Off].
This isa normal operation and nota
malfunction.
To turnoff the sound outputand image pop
up, select [No Sound] and[No Picture].
Slope isnot displayed on Vehi-
cle Dynamics screen.
“Inclination” does notmove on
3D Calibration Statusscreen.
The speedpulse leadis not con-
nected.
Connect the speed pulse lead.
No sound, novoice.
has been set,or sound volume
is reduced to0.
Adjust the volumeof the guidanceor turn
off. (Page 88)
The person on the otherend of
the phone callcannot hear the
conversation due toan echo.
The voice fromthe person on the
other end ofthe phone callis output
from thespeakers and then picked
up bythe microphone again, creat-
ing an echo.
Use the followingmethods to reducethe
echo:
—Lower the volumeon the receiver
—Have both speakerspause slightly before
speaking
The registered phonecannot be
deleted.
Normally,the registered phone can-
not bedeleted.
! Overwrite theold registered phone witha
new phone.
! Clear [Phone Settings]. (Page 187)
Appendix
En
176
Appendix