Filter
Top Products
Vibration detected. Please
power offthe system and
check the installation.Then,
please re-bootthe system and
press “OK”.
The navigation unitis installed ina
place whereit may be affectedby a
large vibration.
Re-install thenavigationunit in a place where
the unitwill not be affectedby vibration.
Direction ofG sensor isnot
correct. Pleasepower off the
system and checkthe installa-
tion. Then, pleasere-boot the
system and press“OK”.
Direction of Gsensor is setincor-
rectly.
See theInstallation Manualand set thedirec-
tion of the navigation unit correctly.
Gyro Sensoris not working
properly. Pleaseconsult your
dealer orPioneer service cen-
ter.
Abnormal Gyrosensor outputis de-
tected.
Writedown the error code shown on the
screen. Turn off the power, and thencontact
your nearest Pioneer service facility.
Positioning is notpossible
due tothe hardware. Please
contact yourdealer or Pioneer
service center.
The location display is not possible
due tohardware failure.
Consult your dealer.
GPS antenna problemde-
tected. Please contact your
dealer orPioneer service cen-
ter.
The location display is not possible
due tofailureof the GPS antenna.
Consult your dealer.
This function is currently una-
vailable.
The screen cannot be displayed with
Vehicle Dynamics Display. The sen-
sor has notbeen taught sothe sen-
sor information cannot be acquired.
If the sensor learning status reachesthe Sen-
sor Initializing, thesystem is ready tobe
used.
The vertical installation angle
is changed. GyroSensor cali-
bration isre-initialized.
If the mounting angleof the naviga-
tion unit hasbeen changed.
The system initializesthe sensor in orderto
operate it withthe maximum performance
and automatically startsre-learning.
Excess vertical installation
angle detected. Pleaseinstall
the navigation unit correctly.
The navigation systemis installed
with anextreme angle exceeding
the limitation ofthe installation
angle.
Confirm the installation angle.(The naviga-
tion system mustbe installed withinthe al-
lowed installation angle. For details refer to
Installation Manual.)
No dataavailable atthis time. Nodata is available thatcan be
used withthe XM tuner.
Wait fora while andtry theoperation again.
UPDATING (Updating) The selected channel is notin-
cluded in your subscription.
Select another channel.
Radio isbeing updated with thelat-
est encryption code.
Wait untilthe encryption code is fully up-
dated.
Route calculation wasnot
possible.
Route calculation has failedbe-
cause of amalfunction in map data,
software, or hardware.
! Change thedestination.
! Consultthe Pioneer Local dealerif this mes-
sage persists.
Route calculation notpossible
because destination is too far.
The destination is too far. ! Seta destination closer tothe starting
point.
! Setone or more waypoints.
Route calculation notpossible
because destination is too
close.
The destination or waypoint(s) are
too close.
Set adestination and waypoint(s) farther
from thestarting point.
Appendix
En
180
Appendix