Filter
Top Products
Chapter 2 PARTS AND THEIR FUNCTIONS
7
Table 2.2 Rear panel parts
No. Part Description of function
(1) Power socket (*1)
Cannon connector, DC power input socket (GND 1pin, DC IN
4pin)
(2) SDI IN A HD-SDI, SD-SDI signal input connector
(3) SDI IN B HD-SDI, SD-SDI signal input connector
(4) MONITOR OUT Output connector for simplified monitoring of SDI input signals
(5) COMPOSITE Composite signal input connector
(6) Remote connector (*2) D-sub 9pin (female)
(7)
Y IN
component Y/G signal input connector
When component input signals are supplied, the Y or G signal is
used for synchronization.
(8) Pb IN component Pb/B signal input connector
*1: Power socket ((1) in rear panel view)
Pin No. Function
1 GND
2 NC
3 NC
4 DC IN (10-18V)
*2: Remote connector ((6) in rear panel view)
The remote controller works only when the REMOTE switch is at the ON setting.
For details on the remote controller, refer to “4.8 Concerning the remote controllers.”
Pin No. Signal Initial value
1 GND -
2 Remote Control TALLY (G) -
3 Remote Control 1 Non
4 Remote Control 2 Non
5 GND -
6 Remote Control 3 Non
7 Remote Control TALLY (R) -
8 Remote Control 4 Non
9 Remote Control 5 Non
1
5
6
9
4
3 2
1