Filter
Top Products
Chapter 3 OPERATION
27
3.4 Description of functions and operating procedures
If an item is accompanied by this mark, it means that its operation can be controlled by the
remote controller. For further details on these operations, refer to “3.4.43 Setting the remote
controllers.”
If an item is accompanied by this mark, it means that its operation can be controlled by one
of the function switches, F1 to F4. For further details on these operations, refer to “3.4.42
Allocating functions to the front panel switches.”
3.4.1 Selecting the input signals
When the front panel switches are used (*1)
1. Press the SDI A switch, the SDI B switch or ANALOG switch.
When the remote controller is used (*2)
1. Press the switch to which the SDI A/B or SDI/VBS function has been
allocated.
The SDI IN CH A or SDI IN CH B input signals are displayed.
2. Set SDI/ANALOG to ANALOG, and select VBS or CMPNT.
The Y IN, Pb IN and Pr IN or COMPOSITE input signals are displayed.
SW
R.C.
R.C.
*1: The SDI A switch is used to display the signals which are input to the SDI
IN CH A connector, the SDI B switch is used to display the signals which
are input to the SDI IN CH B connector, and the ANALOG switch is used
to display the signals which are input to the Y IN, Pb IN and Pr IN
connectors or COMPOSITE connector. Each time the ANALOG switch is
pressed, the display switches between the composite signals and
component signals. The setting displayed last is saved in the ANALOG
switch.
*2: When ANALOG is selected, SDI A/B switches the MONITOR OUT
output.
NOTE