Filter
Top Products
46
3.4.43 Setting the remote controllers
1. Press the MENU switch.
2. Turn the adjustment dial to select REMOTE SETTING , and press the ENT
switch.
3. Turn the adjustment dial to select the remote controller operation method or
item, and press the ENT switch.
4. To change a setting item, turn the adjustment dial further to select the item to
be allocated, and press the ENT switch to enter the item.
Set R1 to R5 to Non if the corresponding remote controllers are
not going to be used.
The remote controller operation method and recommended switches are
given below.
When Level is selected: The slide switches are recommended.
The statuses of the functions are allocated for the open-circuit and
short-circuit statuses respectively.
When Edge is selected: The pushbutton switches are recommended.
The functions are switched at the moment when the open-circuit status
changes to the short-circuit status.
For details on the remote controllers, refer to “4.8 Concerning the remote
controllers.”
NOTE
When one remote controller in which items have already been set has
selected the same item as another remote controller, the item will take effect
in the remote controller in which it was last set. The setting item in the remote
controller which selected the same item first is set to Non , and nothing is
allocated to that remote controller.
Keep the setting at Non if the remote controller is not going to be used.
A remote controller is active only when the remote switch is at the ON
p
osition.
CAUTION