Filter
Top Products
Chapter 3 OPERATION
25
Peaking
This is where peaking is set to ON or OFF.
(Refer to "3.4.20 Setting peaking ON/OFF.”)
Filter
This is where the filter is set to ON or OFF.
(Refer to “3.4.22 Setting the filter to ON or OFF.)
Audio CH
This is where the channels to be displayed by the audio level meter are
selected. (*1)
(Refer to "3.4.25 Selecting the channels to be displayed by the audio level
meter.”)
Tally Type
This is where the tally display method is selected.
(Refer to "3.4.24 Selecting the tally display method.”)
Color Bar
This is where it is selected whether the color bar images are to be displayed
when no signals are input is selected.
(Refer to "3.4.45 Displaying the color bars when no signals are input.”)
Chroma Up
This is where the function for multiplying the chroma signal value by 3 is set to
ON or OFF. (Refer to "3.4.18 Multiplying the chroma signal value by 3.”)
NTSC Setup
This is where the NTSC pedestal level is selected.
(Refer to "3.4.46 Executing the NTSC setup.”)
*1: This is the same function as Audio CH on the other functions setting
screen in section 3.3.13. For this reason, no matter whether it was set
on the audio level meter display setting screen or other functions
setting screen, the same setting will be used for Audio CH.
NOTE
While the peaking function is activated, interpolation processing is stopped,
and the images are displayed by simple pixel skipping. For this reason, fine
lines may not be displayed, and diagonal lines will appear jagged.
CAUTION