Filter
Top Products
12. Accessories
Barco - LC series - R5976934 - user's manual - Revision 08 - April 2008
______________________________________________________________________________________
12-7
12.3.2 Installation
The monitors feature on their rear side 2 parallel arrangements of 4 threads each. The threads comply with the
VESA standards, their horizontal and vertical distance is 200mm. These threads are equipped with the respective
screws (M8x15).
These screws are used to attach the screen bracket!
To install the screen bracket, proceed as follows:
• Lay the monitor upside down on a clean(!) surface.
• Take a screwdriver for recessed head screws (screw size M8).
• Remove the 8 screws and washers on the rear side of the monitor.
• Take the screen bracket, and fix it with the 8 screws and washers as shown below.
The screen bracket is equipped with 3 knurled bolts which are later slid into the fixation
plate of the wall mount / ceiling mount. These bolts are arranged in a triangle. Make sure
that the screen bracket is fixed with the top of the triangle showing to the bottom of the
monitor!