Filter
Top Products
2. Unpacking and installation
Barco - LC series - R5976934 - user's manual - Revision 08 - April 2008
________________________________________________________________________________________
2-3
2.2 Installation
Installation and preliminary adjustments should be performed by qualified Barco
personnel or authorized Barco service dealers.
Installation of the monitor shall comply with the safety instructions as listed in chapter 1.3.1 Safety on installation
• Make sure that the installation place has sufficient stability!
• Do not place the monitor near heat sources!
• Use maximum 15mm/0.59 inch long screws. Longer screws may damage the monitor!
• Ensure that the display is operating within the specified operating range +5°C – +40°C | 41°F – 104°F, at max.
90% RH, non-condensing.
• Never restrict airflow into the display by blocking any vents or air intakes.
• Leave a clearance on all vented sides of the display to permit the required airflow. Clearance should be mini-
mum 15 cm but may be larger depending on the ambient environment.
Do not install the unit where it may be easily touched or leaned against. Avoid locations
subject to high vibrations or severe impacts. Do not install the unit where it is exposed to
humidity, oil, smoke or excessive dust.
2.2.1 Accessories
The product portfolio of accessories comprises a table stand, and wall and ceiling mounts. The installation of the
accessories is described in the installation section. The following chapter just gives a rough idea about mounting
the table stand.
2.2.2 Mounting of the table stand (optional)
The table stand is an optional component.
The monitors feature on their rear side 2 parallel arrangements of 4 threads each. These threads comply with the
VESA standards, their horizontal and vertical distance is 200mm. They are equipped with the respective screws
(M8x15).
These screws are used to attach the table stand!
• Lay the monitor upside down on a clean(!) surface, bottom edge flush with e.g. edge of the table.
Soil or particles laying on the surface may irretrievably
damage the screen of the monitor!