Filter
Top Products
2. Unpacking and installation
2-8
___________________________________________________________
Barco - LC series - R5976934 - user's manual - Revision 08 - April 2008
2.3.3 Rear view
On the rear, all interfaces as well as the power connector and the main power switch are located.
The standardized power socket is conform to IEC-320-13 and allows connecting local power cables. The internal
power supply is auto ranging from 100VAC to 240VAC.
The monitor allows connecting the following sources:
Input Interface signals
Video system input VIDEO IN RCA NTSC/PAL
S-VIDEO S-Video Mini Din 4pin NTSC/PAL
YUV (Y Pb/Cb Pr/Cr) Component Mini Din 7 pin NTSC/PAL
RGB input RGB Analog D-Sub 15 pin RGB analog
RGB Digital DVI-D 24 pin RGB digital
HD-SDI input *) Serial Digital BNC SDI / HD-SDI
HD-SDI output *) Serial Digital BNC SDI / HD-SDI
Signal receive&transmit RS232 IN D-Sub 9 pin
RS232 OUT D-Sub 9 pin
Audio RCA
(red: right (R),
white: left (L))
Audio in (L+R)
Audio out(L+R) (2x) and
Subwoofer
The pin assignments of the interfaces are listed in chapter 7.6 Interfaces and chapter 8.6 Interfaces, respectively.
SW
R/INR/OUT2R/OUT1
L/INL/OUT2L/OUT1
RS232/INRS232/OUT
RGB IN
DVIPr/Cr
Pb/Cb
Y
S-VIDEO
IN
VIDEO
AC IN
OFF
ON
MAIN POWER
HDSDI/SDI IN HDSDI/SDI OUT
Two sources can be viewed simultaneously in either PIP mode (Picture-in-Picture) or PAP mode (Picture-and-
Picture). In case more than one source is connected, the active sources and the display mode (one source or two
sources) are selected via the OSD.
*)
Only LCS-42 and LCS-47 feature the HD-SDI interfaces!