Filter
Top Products
5. The On Screen Display (OSD)
Barco - LC series - R5976934 - user's manual - Revision 08 - April 2008
______________________________________________________________________________________
5-31
5.4.4 Time out
The value can be set between 0 and 60 seconds in steps of 5 seconds.
The OSD will close (disappear) automatically when no selections are made during a certain time. This period can
be set by means of the Time out parameter.
The OSD stays active as long as it is in use.
Independent from the Time out setting, you can close the OSD at any time by using the Exit
button the RCU or the push button 7 on the right rear side of the monitor.
RCU Push button (1: top most)
• Use the up and down cursor keys to navigate to
the Time out
• Press 5 and 6 to navigate to Time out
• Use the left and right cursor keys to in-
crease/decrease the value in steps of 5
The current value is indicated.
• Use 3 and 4 to increase/decrease the value in
steps of 5
The current value is indicated.
The value is applied without any further action.
5.4.5 OSD Zoom
Zoom can be selected in or out.
This command will magnify the OSD window and the icons by approx. the factor of 2.
RCU Push button (1: top most)
• Use the up and down cursor keys to navigate to
the OSD Zoom
• Press 5 and 6 to navigate to OSD Zoom
• Use the left and right cursor keys to select one
of the options In, Out
The current selection is visualized by a white
caption.
• Use 3 and 4 to select one of the options In, OUt
The current selection is visualized by a white cap-
tion.
• Apply the selection with Enter. • Apply the selection with 2
This selection has to be confirmed to be applied.