Filter
Top Products
2. Unpacking and installation
Barco - LC series - R5976934 - user's manual - Revision 08 - April 2008
________________________________________________________________________________________
2-9
2.4 Cabling
All interfaces are located on the rear of the system!
Check the power rating on your outlet before connecting the monitor to the wall outlet
or to a power strip. Contact your facilities manager or a qualified electrician if you are
not sure what type of power is supplied to your building.
The devices are designed to operate with single-phase power systems having a
grounded neutral conductor. To reduce the risk of electrical shock, do not plug into any
other type of power system.
• Use the power cord delivered with your system:
• Plug in the female power connector into the male connector AC IN on the rear of the monitor.
• Plug in the CEE7-plug (or ANSI 73.11 plug) into the wall outlet.
The power input is auto-ranging from 100VAC to 240 VAC.
• Connect the video and RGB sources with the respective interface using the included cables.
2.5 Switching on and off
Use the main power switch on the rear of the system to power the system on and off.
When the monitor is powered on, it can be switched into operation or switched to standby, respectively, using
eater the top most push button on the rear right side of the monitor or using the IR remote control unit (RCU).
If the system is not operated for longer periods, it is recommended to switch it off using
the main power switch on the rear side and to disconnect it from the wall outlet.
When the monitor is powered off by switching off the main power switch, the front LED indicating the operating
mode is off! Also you cannot switch the unit into operation by using the remote control unit or the top most push
button.
To power on the unit, switch on the main power switch on the rear of the system. The LED indicator will be
turned on, and you can switch the monitor into operation either by using the RCU or the top most push button
the rear of the system.