172 CHAPTER 7: IP SERVICES COMMANDS
History —Introduced in MSS Version 3.0.
Examples — The following command changes the Telnet port number
on a WX switch to 5000:
WX4400# set ip telnet 5000
success: change accepted.
See Also
clear ip telnet on page 131
display ip https on page 145
display ip telnet on page 148
set ip https server on page 167
set ip telnet server on page 172
set ip telnet server Enables the Telnet server on a wireless LAN switch.
CAUTION: If you disable the Telnet server, Telnet access to the WX
switch is also disabled.
Syntax —
set ip telnet server {enable | disable}
enable — Enables the Telnet server.
disable — Disables the Telnet server.
Defaults — The Telnet server is disabled by default.
Access — Enabled.
Usage — The maximum number of Telnet sessions supported on a WX
switch is eight. If SSH is also enabled, the WX switch can have up to eight
Telnet or SSH sessions, in any combination, and one console session.
Examples — The following command enables the Telnet server on a WX
switch:
WX4400# set ip telnet server enable
success: change accepted.
See Also
clear ip telnet on page 131
