display auto-tune neighbors 311
set radio-profile auto-tune channel-interval on page 351
set radio-profile auto-tune power-backoff- timer on page 352
set radio-profile auto-tune power-config on page 353
set radio-profile auto-tune power-interval on page 354
display auto-tune
neighbors
Displays the other 3Com radios and third-party 802.11 radios that a
3Com radio can hear.
Syntax —
display auto-tune neighbors
[ap map-num [radio {1 | 2| all}]]
Syntax — display auto-tune neighbors
[dap dap-num [radio {1 | 2| all}]]
map-num — MAP port connected to the MAP access point for which to
display neighbors.
dap-num — Number of a Distributed MAP for which to display
neighbors.
radio 1 — Shows neighbor information for radio 1.
radio 2 — Shows neighbor information for radio 2. (This option does
not apply to single-radio models.)
radio all — Shows neighbor information for both radios.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — For simplicity, this command displays a single entry for each
3Com radio, even if the radio is supporting multiple BSSIDs. However,
BSSIDs for third-party 802.11 radios are listed separately, even if a radio is
supporting more than one BSSID.
Information is displayed for a radio if the radio sends beacon frames or
responds to probe requests. Even if a radio’s SSIDs are unadvertised,
3Com radios detect the empty beacon frames (beacon frames without
SSIDs) sent by the radio, and include the radio in the neighbor list.
