316 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
See Also
display {ap | dap} config on page 290
display dap connection on page 313
display dap unconfigured on page 316
set dap on page 81
set {ap | dap} bias on page 328
display dap
unconfigured
Displays Distributed MAPs that are physically connected to the network
but that are not configured on any WX switches.
Syntax —
display dap unconfigured
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command also displays a MAP that is directly connected to
a WX switch, if the WX port to which the MAP is connected is configured
as a network port instead of a MAP access port, and if the network port is
a member of a VLAN.
If a Distributed MAP is configured on a WX switch in another Mobility
Domain, the MAP can appear in the output until the MAP is able to
establish a connection with a WX switch in its Mobility Domain. After the
MAP establishes a connection, the entry for the MAP ages out and no
longer appears in the command’s output.
Entries in the command output’s table age out after two minutes.
Examples — The following command displays information for two
Distributed MAPs that are not configured:
WX1200# display dap unconfigured
Total number of entries: 2
Serial Id Model IP Address Port Vlan
------------- ------ --------------- ---- --------
M9DE48B012F00 AP2750 10.3.8.54 5 default
M9DE48B123400 AP2750 10.3.8.57 6 vlan-eng
