12
STP COMMANDS
Use Spanning Tree Protocol (STP) commands to configure and manage
spanning trees on the virtual LANs (VLANs) configured on a wireless LAN
switch or controller, to maintain a loop-free network.
STP Commands by
Usage
This chapter presents STP commands alphabetically. Use the following
table to locate commands in this chapter based on their use.
Table 68 STP Commands by Usage
Type Command
STP State set spantree on page 410
display spantree on page 398
display spantree blockedports on page 401
Bridge Priority set spantree priority on page 419
Port Cost set spantree portcost on page 414
set spantree portvlancost on page 417
display spantree portvlancost on page 403
clear spantree portcost on page 394
clear spantree portvlancost on page 395
Port Priority set spantree portpri on page 416
set spantree portvlanpri on page 418
clear spantree portpri on page 395
clear spantree portvlanpri on page 396
Timers set spantree fwddelay on page 412
set spantree hello on page 412
set spantree maxage on page 413
Fast Convergence set spantree portfast on page 415
display spantree portfast on page 402
