Filter
Top Products
Editing Programs: Chapter 6
QuadraSynth Plus Piano Reference Manual 108
not already there) when the note is released and the sustain
pedal is held down. If a long attack is set, and the envelope does
not reach the end of the attack segment when the note is
released, it will be skipped and the envelope will jump
immediately to the release segment. If a long delay is set, and the
envelope has not reached the attack segment before the note is
released, the envelope will remain at 0. However, if Freerun is
turned on, the envelope will continue through the delay, attack,
decay and sustain segments and remain at the sustain decay
segment. This is exactly the same as holding down the note on
the keyboard. When the Sustain Pedal parameter is turned off,
the Sustain Pedal will have no effect on the envelope.
Level (00 to 99)
This is the overall output level of the envelope. If this is set to 00,
the PENV will have no output and will have no effect, while at
99 it will have a maximum effect on whatever it is being routed
to. Tip: When selecting PENV Level as a modulation destination,
set the PENV level to 00 if the Modulation Level is above 0 (or,
set the PENV level to 99 if the Modulation Amount is below 0).