Filter
Top Products
Your First Session With The QuadraSynth Plus: Chapter 2
QuadraSynth Plus Piano Reference Manual 25
Editing a Mix
In this section, we will assign Programs to and set volume levels for the
16 MIDI channels in a Mix, for playing back tracks from a MIDI
sequencer. However, there is much more about a Mix that may be edited.
Refer to Chapter 5 for more about Mix editing.
¿ Press [MIX] and select a Mix using one of the three methods
described above.
¡ Press [SELECT].
The top line of the LCD’s function list will read “EDITING: MIX”.
¬ Simultaneously press both the FUNCTION [♦] and [∅] buttons.
PROG EFFECT
EDITING: MIX
P AGE: 1
PITCH RANGE EFFECT NAME
MIX
1 2 3 4 5 6 7 8 9 10 1 1 12 13 14 15 16
PROGRAM – ASSIGN LEVEL EFFECT–LEVEL
Use the MIDI [♦] and [∅] buttons to select a MIDI channel for
editing.
The MIDI monitor and selection strip will indicate the selected MIDI channel
with an underline. These buttons “wrap around” (e.g., if you’re on channel 16
and press MIDI [∅], you’ll select channel 1. If channel 1 is selected and you
press MIDI [♦], you’ll select channel 16).
ƒ Use Quad Knob [1] to choose a Bank (User, Preset 1 – 4).
H Use Quad Knob [2] to select a Program for the selected Channel.
J
Don’t use the MIX/PROGRAM SELECT [1]—[0] buttons while in any edit
mode. If you do, you will be kicked out of Mix Edit mode and will select another
Mix, losing your changes.
Use Quad Knob [4] to enable or disable the Program on the
selected Channel.
When enabled, the Channel number will appear in the top left of the display.
When disabled, the Channel number will not appear (unless selected for editing
using the MIDI [♦] and [∅] buttons, in which case it is underlined).
« To set the Program’s level, press the FUNCTION [∅] button
once so that “LEVEL” is underlined in the display. Use Quad Knob [1] to
adjust the level.