Filter
Top Products
Editing Effects: Chapter 7
QuadraSynth Plus Piano Reference Manual 160
depending on the effect chosen. However, the Mod Destinations retain
their names. Example: If the Resonator is the Pitch effect, the Pitch Speed
Modulation Destination controls the first parameter in the Resonator
(Tuning).
Mod Level
The Mod level is the amount that the Destination parameter will be
affected by the Mod Source. Use Quad Knob [3] to affect the Destination
parameter by a positive or negative amount. Example: If the Reverb
Decay was selected as the Destination with the mod wheel as the Source,
the mod wheel could be programmed to cause the Reverb to increase the
decay (positive) or decrease the decay (negative).
Mix
Not to be confused with an actual Mix or Mix mode, the Effect’s Mix function is
where you can mix the various signal levels of all the effects to the Main Left and
Right outputs of the QuadraSynth Plus. Only effect modules that have access to
the Main outputs will appear on the Mix page. There is a separate Mix page for
each of the four effect busses whose effect modules feed the main output. Note
that the Mix page doesn't control how much the individual effect modules feed
to each other; only how much they feed to the Main outputs.
MIDI
CHAN
PROGPROG
1
PRESET
EDITING: 1 EFFECT
PITCH MOD
CONFIG REVERB DELA Y MIX MISC.
P AGE: 1
DELAY OUTPUT: 50
DELAY PITCH REVERB
Depending on the selected Configuration, the order of the effects will differ (for
example: in Configuration #1, the order reads Pitch, Delay, Reverb; but in
Configuration #2, the order is Delay, Pitch, Reverb).
Pitch Level
Adjusting this value will cause the Pitch Output Level to increase or
decrease. The Pitch Output level is the level for the Pitch Section of the
QuadraSynth Plus’s effects processor to the Main outputs, and should be
set as desired. Even if this parameter is set to 00, the output of the Pitch
section is still available (depending on the bus and configuration) to
following Delay and Reverb sections.
Delay Level
Adjusting this value will cause the Delay Output Level to increase or
decrease. The Delay Output level is the level for the Delay Section of the
QuadraSynth Plus’s effects processor to the Main outputs, and should be
set as desired. Even if this parameter is set to 00, the output of the Delay