Filter
Top Products
Editing Programs: Chapter 6
QuadraSynth Plus Piano Reference Manual 116
already there) when the note is released and the sustain pedal is
held down. If a long attack is set, and the envelope does not
reach the end of the attack segment when the note is released, it
will be skipped and the envelope will jump immediately to the
sustain decay segment. If a long delay is set, and the envelope
has not reached the attack segment before the note is released,
the envelope will remain at 0. However, if Freerun is turned on,
the envelope will continue through the delay, attack, decay and
sustain segments and remain at the sustain decay segment. This
is exactly the same as holding down the note on the keyboard.
When the Sustain Pedal parameter is turned off, the Sustain
Pedal will have no effect on the envelope.
Level (00 to 99)
This is the overall output level of the envelope. If this is set to 00,
the AENV will have no output and will have no effect, while at
99 it will have a maximum effect on whatever it is being routed
to. Tip: When selecting AENV Level as a modulation destination,
set the AENV level to 00 if the Modulation Level is above 0 (or,
set the AENV level to 99 if the Modulation Amount is below 0).