Filter
Top Products
MIDI Transfer and Storage Operations: Chapter 9
QuadraSynth Plus Piano Reference Manual 175
To send the entire User bank via MIDI:
¿ Connect a MIDI cable from the QuadraSynth Plus’s MIDI Out to the
MIDI In of a device capable of receiving the data (S4, another QuadraSynth Plus,
etc.).
¡ Press [STORE].
¬ Use either PAGE [♦] or [∅] to select Page 3 of the Store function.
Turn Quad Knob [1] to the right until the upper right display reads
“SEND_ALL TO MIDI.”
ƒ Press [STORE] to transmit the data out the MIDI Out connector.
To send a single Program via MIDI:
¿ Follow steps ¿ through ¬ in the instructions above.
¡ Use Quad Knob [1] to select a Program. You may select any Program in
the User bank (0 to 127) or the Program Edit buffer (EDIT) or any of the 16 Mix
Edit buffers (EDm01 to EDm16).
As this value is changed, the second parameter (destination) will be linked. This is
because most often you will want to transmit a Program to the same Program location.
The only time to do otherwise is when sending to another QuadraSynth Plus (see below).
¬ Press [STORE] to transmit the data out the MIDI Out connector.
To send a single Program via MIDI to a different Program number:
¿ Follow steps ¿ through ¬ in the instructions above.
¡ Use Quad Knob [1] to select a Program. You may select any Program in
the User bank (0 to 127) or the Program Edit buffer (EDIT) or any of the 16 Mix
Edit buffers (EDm01 to EDm16).
As this value is changed, the second parameter (destination) will be linked.
¬ Use Quad Knob [2] to select a Program number to send the selected
Program to.
If this value is turned all the way up, the “SEND ALL TO MIDI” option will be selected
and the first value will jump all the way up. At this point you will not be able to adjust
the destination value with Quad Knob [2] until you use Quad Knob [1] to re-select the
Program to be transmitted.
Press [STORE] to transmit the data out the MIDI Out connector.
The procedure is similar for sending Mixes. Page 4 of the Store function allows
you to send any one of the Mixes.
Similarly, if a Mix is stored, you may want to store each of the Programs used in
the Mix. The “SEND ALL TO MIDI” command in the Program Store function is
an easy shortcut to this.