Filter
Top Products
Editing Programs: Chapter 6
QuadraSynth Plus Piano Reference Manual 125
Copying Sounds
While editing a Program, it is helpful to be able to copy a sound to another sound
in either the same Program or a different Program, especially if you are building
a split or layered Program. This can be done very easily from within the Store
function.
To copy a sound to another sound in the same Program, or to the same sound in
a different Program:
¿ From Program Edit mode, press [STORE].
¡ Press PAGE [∅] to select Page 2 of the Store function.
¬ Use Quad Knob [1] to select which sound (1–4) in the currently selected
Program to copy from.
Use Quad Knob [2] to select which sound (1–4) in the currently selected
Program to copy to; or to select which Program (0–127) to copy to.
The selected sound will be copied into the same sound location in the selected Program. If
you select to copy sound 2 to Program 45, the sound will be copied into sound 2 of
Program 45.
ƒ Press [STORE] to copy the sound.
Copying Effects
While editing a Program, it is helpful to be able to copy the Effects Patch from a
different Program. This can be done very easily from within the Store function.
J
Be sure to save your changes to the edited Program before going to a new Program.
Otherwise, all your changes will be lost.
To copy the Effects Patch from a Program to another Program:
¿ Recall the Program which contains the Effects Patch you wish to copy,
using the methods described on page 14.
¡ Press [STORE].
¬ Press PAGE [∅] to select Page 2 of the Store function.
Use Quad Knob [1] to select “EFFECT”, which is the Effects Patch in the
currently selected Program to copy from.
ƒ Use Quad Knob [2] to select which Program (0–127) in the User Bank to
copy to.
The selected sound will be copied into the same sound location in the selected Program. If
you select to copy sound 2 to Program 45, the sound will be copied into sound 2 of
Program 45.