Filter
Top Products
Editing Effects: Chapter 7
QuadraSynth Plus Piano Reference Manual 145
Input level
Quad Knob [4] controls the overall Input Level going into the
Reverb.
Chorus Input Level
If Configuration #2 is selected (refer to block diagram of
Configuration #2, earlier in this chapter), the first page of the
Reverb function will look like this:
MIDI
CHAN
PROGPROG
1
PRESET
EDITING: 1 EFFECT
PITCH MOD
CONFIG REVERB DELA Y MIX MISC.
P AGE: 1 2 3 4
The Configuration has two Reverbs, one on send 1 (which send 2
can share), the other on send 3 (which send 4 can share). There is
only one parameter in this page: Chorus Input Level. Quad
Knob [1] lets you adjust the level of the signal coming from the
Pitch output going into the Reverb, otherwise the signal comes
purely from the Pitch input.
The other parameters and pages in the Reverb function are
identical, regardless of which Configuration is being used. Only
page 1 is different, because of the fewer input choices the Reverb
has in this Configuration.
Send Input Levels
If Configuration #1 is selected and you press [EDIT 1] to
advance to effect send 2, the display will now show you the
parameters that represent the signal levels on send 2 going into
the Reverb. Note that there is now only 1 page available, since
the other reverb parameters are found back on effect send 1.
Press [EDIT 1] again to advance to send 3, and the display will
still look the same, but now the parameters adjust the signal
levels on send 3 going into the Reverb. If you press [EDIT 1]
again and advance to send 4, the display will look like this: