Alesis QuadraSynth Plus Car Speaker User Manual


 
Editing Effects: Chapter 7
QuadraSynth Plus Piano Reference Manual 131
sends 1, 2 and 3 in Configuration #1, but not on send 4—as you can see in the
chart on page 92.
Although only used in Configuration #s 4 and 5, the word “MISC.” will appear
in the display. This can be selected in the same manner as any other function
using the FUNCTION [] and [] buttons. The MISC function is where you
access the EQ parameters used in Configuration #4, and the Overdrive effect’s
parameters in Configuration #5. If you are using Configuration #s 1–3, and you
select the MISC function, the display will read “(NOT IN CONFIG)”, since there
are no EQ or Overdrive parameters in these configurations.
Storing Effect Patches In Program Mode
Effects are an extension of a Program. So, when you store a Program, you store
its Effects Patch along with it. Once a Program’s Effect Patch has been altered, the
display will show the word “EDITED” next to the Program number (if in
Program Mode; when editing the Effect Patch in Mix mode, the word “EDITED”
will appear next to the Program number only when the Effect Channel is
selected). This indicates that the current Effect Patch in the edit buffer is different
from what is stored in memory for the selected Program.
While in Effects Edit mode, press [STORE] at any time to go to Store mode. Store
mode has several pages, but the main storing function is found in the first page.
MIDI
CHAN
PROGPROG
1
PRESET
P AGE: 1 2 3 4 5 6
To store the edited Program along with its Effect Patch into the same location it
was recalled from, simply press [STORE] again, and it will be stored. To store the
edited Program into a different location, use Quad Knob [2] to select a different
Program number (000—127) in the User Bank to store it to. If a RAM Sound Card
is inserted, you can use Quad Knob [1] to select a Card Bank to store the Program
to.
Storing Effect Patches in Mix Mode
When in Mix Play Mode or Mix Edit Mode, the Effect Program number shown in
the display is the Program number selected as the Effect Channel. Storing the
Mix will save this number, but will not store any changes you may have made to
the Effect Patch itself.
If [STORE] is pressed twice while editing a Program that is on the Effect
Channel, both the Program and its Effects will be stored.