Filter
Top Products
Setting Up: Chapter 1
QuadraSynth Plus Piano Reference Manual 9
CHAPTER 1
SETTING UP
Unpacking and Inspection
Your QuadraSynth Plus was packed carefully at the factory. The shipping carton
was designed to protect the unit during shipping. Please retain this container in
the highly unlikely event that you need to return the QuadraSynth Plus for
servicing.
Upon receiving the QuadraSynth Plus, carefully examine the shipping carton
and its contents for any sign of physical damage that may have occurred in
transit. If you detect any damage, do not destroy any of the packing material or
the carton, and immediately notify the carrier of a possible claim for damage.
Damage claims must be made by you. Contact your Alesis dealer.
The shipping carton should contain the following items:
• QuadraSynth Plus with the same serial number as shown on shipping
carton
• Sustain pedal
• AC Power Cable
• Computer floppy disk containing Sound Bridge software and electronic
manual
• This instruction manual, plus lists of Mixes and Programs, and Quick
Start guide
• Alesis warranty card
J
It is important to register your purchase; if you have not already filled out your warranty
card and mailed it back to Alesis, please take the time to do so now.
AC Power Hookup
The QuadraSynth Plus works with the voltage of the country it is shipped to
(either 110 or 220V, 50 or 60 Hz), and comes with a line cord or power supply
suitable for the destination to which the keyboard is shipped.
With the QuadraSynth Plus off, plug the AC cord’s female (jack) end into
Quadra-Synth Plus’s AC socket and the male (plug) end into a source of AC
power. It’s good practice to not turn the QuadraSynth Plus on until all other
cables are hooked up.
The IEC-spec AC cord included with the QuadraSynth Plus (do not substitute
any other AC cord) is designed to connect to an outlet that includes three pins,
with the third, round pin connected to ground. The ground connection is an
important safety feature designed to keep the chassis of electronic devices such
as the QuadraSynth Plus at ground potential. Unfortunately, the presence of a
third pin does not always indicate that it is properly grounded. Use an AC line