Filter
Top Products
MIDI Supplement: Appendix B
QuadraSynth Plus Piano Reference Manual 187
There are three MIDI registered parameters which the QuadraSynth plus will
recognize in Mix Play Mode when General MIDI Mode is enabled. These are:
• MIDI Registered Parameter 0 (Pitch Bend Sensitivity): This will directly
effect the Pitch Wheel Range parameter of all four Sounds of the Program on the
received MIDI Channel of the Mix. If the Channel is selected using the MIDI [♦]
and [∅] buttons, the word “Edited” will appear next to the Program Number in
the display if this parameter is received. However, if you are viewing the Pitch
Wheel Range parameter in the display (Program Edit Mode, Pitch Function, Page
2, Quad Knob [2]), the display will not be updated to reflect the new setting. If
you go to another Page or Function and then return to it, the display will now
reflect the updated setting.
• MIDI Registered Parameter 1 (Fine Tune): This will directly effect the
Detune Amount parameter of all four Sounds of the Program on the received
MIDI Channel of the Mix. If this MIDI registered parameter is received, the
QuadraSynth will automatically make sure that all four Sounds of the Program
have their Detune Type parameter set to “Normal” (Program Edit Mode, Pitch
Function, Page 1, Quad Knob [4]). If the Channel is selected using the MIDI [♦]
and [∅] buttons, the word “Edited” will appear next to the Program Number in
the display if this parameter is received. However, if you are viewing the Detune
Amount parameter in the display (Program Edit Mode, Pitch Function, Page 1,
Quad Knob [3]), the display will not be updated to reflect the new setting. If you
go to another Page or Function and then return to it, the display will now reflect
the updated setting.
• MIDI Registered Parameter 2 (Coarse Tune):This will directly effect the
Tune Semitone parameter of all four Sounds of the Program on the received
MIDI Channel of the Mix. If the Channel is selected using the MIDI [♦] and [∅]
buttons, the word “Edited” will appear next to the Program Number in the
display if this parameter is received. However, if you are viewing the Tune
Semitone parameter in the display (Program Edit Mode, Pitch Function, Page 1,
Quad Knob [1]), the display will not be updated to reflect the new setting. If you
go to another Page or Function and then return to it, the display will now reflect
the new setting.
(Parts of this appendix are abridged versions of material from Power Sequencing
with Master Tracks Pro/Pro 4 and The Complete Guide to the Alesis HR-16 and
MMT-8, copyright 1990 and 1989 respectively by AMSCO Publications, and is
adapted with permission.)