Denon AVR-4520CI Car Satellite TV System User Manual


  Open as PDF
of 227
 
123
Tone
Default settings are underlined.
Adjust the tonal quality of the sound.
Setting items Setting details
Tone Control
Set the tone control function
to “On” and “Off”.
On : Allow tone adjustment (bass, treble).
Off : Playback without tone adjustment.
“Tone Control” can be set when “Dynamic EQ” (vpage125) is set
to “Off”.
NOTE
•“Tone Control” settings are not reflected to ZONE2 and ZONE3.
•The tone cannot be adjusted in the “DIRECT” and “PURE DIRECT”
mode.
Bass
Adjust bass.
–6dB – +6dB (0dB)
“Bass” can be set when the menu “Tone Control” setting is “On”.
Treble
Adjust treble.
–6dB – +6dB (0dB)
“Treble” can be set when the menu “Tone Control” setting is “On”.
Audio
Setting items Setting details
Height Gain
Control the front height
channel volume.
Low : Reduce the front height channel volume.
Normal : Front height channel sound is output with standard sound
volume.
High : Increase the front height channel volume.
NOTE
“Height Gain” is displayed for the following settings.
•When the “Speaker Config.” – “Front Height” setting (vpage142) is
set other than to “None”.
•When sound mode is “PLgz” or the PLgz decoder is used.
Speaker Select
Makes settings for the
speakers outputting sound.
n When “Assign Mode” (vpage 141) is set to “7.1ch + ZONE2”, “7.1ch +
ZONE2/3-MONO” and “7.1ch(Bi-Amp)”
Surround Back : Sound is output from the surround back speakers.
Height : Sound is output from the front height speakers.
Wide : Sound is output from the front wide speakers.
n When “Assign Mode” (vpage141) is set to “9.1ch(SB/FH/FW)”
Back/Height : Sound is output from the surround back and front height
speakers.
Back/Wide : Sound is output from the surround back and front wide
speakers.
Height/Wide : Sound is output from the front height and front wide
speakers.
NOTE
Only speakers that are set to something other than “None” in “Speaker
Config.” (vpage142) can be selected.
Set Defaults
The “Surround Parameter”
settings are returned to the
default settings.
Reset : Reset to the defaults.
Cancel : Do not reset to the defaults.
When you select “Set Defaults” and press
ENTER, the “Reset all surround parameters
to the factory defaults?” prompt is displayed.
Select either “Reset” or “Cancel”, and press
ENTER.
Basic version
Advanced version
Informations
Advanced version
DVD
 previous next