Filter
Top Products
163
Operating learning function
If the AV device is not a DENON device, or if the device does not
operate even when the preset code is registered, use the learning
function. Remote codes for different devices can be remembered for
use by the DENON remote control included with this device.
Remembering remote control codes from
other devices
1
Press and hold RC SETUP for at
least 3 seconds.
“SETUP” and indicator flashes twice
on the remote control unit.
2
Use ui to display “LEARN” on
the remote control unit and press
ENTER.
3
When “DEVIC” appears on the
remote control unit, press the
input source select button of the
AV equipment that you want to
store.
•You cannot store the remote control code
in the AVR button.
•Before using the learning function, register
a preset code (vpage157 “Registering
preset codes”) for a mode other than AVR
preset (vpage158) to each input source
switch button.
4
When “KEY” appears on the remote control unit,
press the button that you want to store.
•You cannot store the remote control code in the ZONE SELECT,
RC SETUP, POWER X, FAVORITE STATION 1 – 4, InstaPrevue,
SOUND MODE, SLEEP, MACRO A – D and input source select
button.
5
When “READY” appears on the remote control unit,
place the remote control unit of the AV equipment
face to face with main remote control unit (of this
unit). Next, press and hold down the desired button
(that you want to store) of the remote control unit of
the AV equipment.
•When the button is correctly stored, “OK” flashes four times on
the remote control unit.
•If the button is not correctly stored, “FAIL” flashes four times on
the remote control unit. If this happens, perform step 4 again.
6
To store another button, repeat steps 4 and 5.
7
When you have nished storing the remote control
codes, press RC SETUP.
“OK” flashes four times on the remote control unit and the
normal operation mode is restored.
•There are some remote control units that cannot be programmed,
or even if they can be programmed, they may not operate correctly.
If this happens, use the remote control unit supplied with the AV
equipment to operate it.
•The operations of the programmed buttons override the preset
memory. If you do not require the programmed buttons, erase
the stored remote control codes to return to the initial settings
(vpage164 “Erasing stored remote control codes”).
•The number of buttons that can be stored varies depending on the
remote control unit used. If you have stored the maximum number
of buttons allowed for the remote control unit, “FAIL” appears on
its display.
Basic version
Advanced version
Informations
Advanced version
DVD