Filter
Top Products
166
Operating macro function
Recording custom macro operations
1
Press and hold RC SETUP for at
least 3 seconds.
“SETUP” and indicator flashes twice
on the remote control unit.
2
Use ui to display “MACRO” on
the remote control unit and press
ENTER.
3
Use ui to display “MAN” on
the remote control unit and press
ENTER.
4
When “MCNo” appears on the
remote control unit, press the
MACRO A – D button that you
want to store.
5
Press the buttons to be stored one
by one.
•The step number for the storing procedure and mode are alternately
displayed on the remote control unit.
NOTE
You cannot store the macros for the ZONE SELECT button.
6
Press MACRO to exit the macro function.
“OK” flashes four times on the remote control unit and the
normal operation mode is restored.
Adjusting the interval time of macro
operations transmitting
The macro operation transmission interval can be adjusted.
•The factory setting is “0.5 sec”.
1
Press and hold RC SETUP for at
least 3 seconds.
“SETUP” and indicator flashes twice
on the remote control unit.
2
Use ui to display “MACRO” on
the remote control unit and press
ENTER.
3
Use ui to display “MAN” on
the remote control unit and press
ENTER.
4
When “MCNo” appears on the
remote control unit, press the
MACRO A – D button that you
want to set.
5
Press RC SETUP.
6
Use ui to set the macro operation transmission
interval and press ENTER.
“OK” flashes four times on the remote control unit and the
normal operation mode is restored.
Remote control unit
display
Time values that you can set
0.25 0.25 sec
0.50 0.5 sec
0.75 0.75 sec
1.00 1 sec
1.25 1.25 sec
Using the macro function
Press the MACRO A – D button you
used to store the macro function.
Resetting the macro function
1
Press and hold RC SETUP for at
least 3 seconds.
“SETUP” and indicator flashes twice
on the remote control unit.
2
Use ui to display “RESET” on
the remote control unit and press
ENTER.
3
Use ui to display “MACRO” on
the remote control unit and press
ENTER.
4
When “MCNo” appears on the
remote control unit, press the
MACRO A – D button that you
want to reset.
“RESET” flashes four times on the
remote control unit and the normal
operation mode is restored.
Basic version
Advanced version
Informations
Advanced version
DVD