Denon AVR-4520CI Car Satellite TV System User Manual


 
35
Preparation (Continued)
Detection & Measurement (Main)
Set up speakers (Audyssey
®
Setup)
5
Select “Start” and then press
ENTER.
Audyssey Setup
Back Next
Open the front panel door and connect the calibration
microphone to the SETUP MIC input.
6
Select “Next” and then press ENTER.
The subwoofer volume setting screen is displayed.
Audyssey Setup
Back Next
Make sure your subwoofer is plugged in and turned on. If your
subwoofer has a volume control on it, please set it at 50%...
VOLUMEPOWER
ON
OFF
MIN
MAX
NOTE
If “Caution!” is displayed on TV screen:
Go to “Error messages” (vpage 38). Check any related items,
and perform the necessary procedures.
If the problem is resolved, return and restart “Audyssey
®
Setup”.
Going back to the previous screen
Select “Back” and then press ENTER.
When measuring has stopped
q Press BACK to display the popup screen.
w Press o to select “Yes”, and then press ENTER.
Setting up the speakers again
Repeat the operation from step 4.
This step automatically checks the speaker configuration and speaker
size, and calculates the channel level, distance, and crossover
frequency.
It also corrects distortion in the listening area.
7
Select “Begin Test” and then press ENTER.
The volume level for the subwoofer is measured.
•If the volume level for the subwoofer is not appropriate, an error
message is displayed. See “Subwoofer level error message and
how to adjust” (vpage39) and adjust the volume level for the
subwoofer.
•Measurement requires several minutes.
•To stop measuring, select “Cancel” and then press ENTER.
8
The detected speakers are displayed.
•The illustration below shows an example of when the front
speakers, center speaker, subwoofer, surround and surround back
speakers have been detected.
Audyssey Setup
Repeat Last Test Next
Speaker Detection
Front
Center
Subwoofer
Surround
Surr. Back
:Yes
:Yes
:2spkrs
:Yes
:2spkrs
NOTE
If a connected speaker is not displayed, the speaker may not be
connected correctly. Check the speaker connection.
9
Select “Next” and then press ENTER.
Basic version
Advanced version
Informations
Basic version
v See overleaf
DVD