Filter
Top Products
Print Data *Manual Number Revision
Jul., 2007 SH(NA)030051-C Section 11.11(1)
Section 11.12
Section 11.13
Section 11.14
Section 11.18
Section 11.19
Section 11.19(1)
Section 11.19(3)
Section 12.3(1)
Chapter 13
Section 13.1.6(1)
Section 13.1.6(2) (3)
Section 13.1.7
Section 13.3
Section 13.3.1(1) (a)
Section 13.3.1(1) (b)
Section 13.3.1(2) (a)
13.3.1(2) (b)
13.3.2(1), (2)
Section 13.3.4(2)
Section 13.3.6
Section 13.3.7
Section 13.4.3(2) (b)
Section 13.4.3(3)
: Addition of cable diameter for MR-J3-60B4 to 350B4,
addition of Note 3: Cable 5) to 7) of MR-J3-700B(4)
: Addition of MR-J3-60B4 to 350B4 compliant products
Addition of no-fuse breakers, fuses and magnetic
contactors for MR-J3-500B4 and 700B4
: Addition of MR-J3-60B4 to 350B4 compliant products,
unification of (1) and (2)
Addition of power factor improving DC reactors for MR-
J3-500B4 and 700B4 Change of (2) Note2 Addition of
Note3
: Addition of MR-J3-60B4 to 350B4 compliant products
Addition of power factor improving AC reactors for MR-
J3-500B4 and 700B4
: Addition of MR-J3-60B4 to 350B4 as earth leakage
circuit breaker selection example
: Addition of EMC filter for MR-J3-500B4 and 700B4
: Addition of MR-J3-60B4 to 350B4 compliant products,
deletion of Note from TX series
: Addition of TF3005C-TX
: Addition of description for 30kW or more in
“WARNING”, Addition of POINT
: New addition of the details for 30kW or more
Change of notation "magnet contactor" to "magnetic
contactor"
: Change of description "I/O signal connector" to "Digital
I/O connector", addition of rating plate
Change in description of CN3 and CN6
: Change of rating plate designated position
: Enlargement of diagram for removing and reinstalling
terminal block cover
: Addition of POINT: reference "Signal (device)
explanations, section 3.5"
: Revision of magnetic contactor sequence, addition of
Note 3
: Revision of magnetic contactor sequence, addition of
Note 3 and 4
: Revision of magnetic contactor sequence, addition of
Note 3 and 4, addition of magnetic contactor control
(CNP1)
: Revision of magnetic contactor sequence, addition of
Note 3 to 5, addition of magnetic contactor control
(CNP1)
: Change of description in Note for "servo motor output"
and "servo motor power supply" to "servo motor power"
: Correction of reference for CN2 and CN3
: Raise of section 13.3.5 (3) to section 13.3.6
: Raise from section 13.3.6, Change of description in
chart: "servo motor power" to "servo motor power
supply"
: Change of display
: Deletion