Mitsubishi Electronics MR-J3- B Car Amplifier User Manual


 
Print Data *Manual Number Revision
Jul., 2007 SH(NA)030051-C Section 13.5.2
Section 13.6.1(3)
Section 13.8.1
Section 13.9.1
Section 13.9.2(5)
Section 13.9.3(2)
Section 13.9.3(3)
Section 13.9.4
Section 13.9.5
Section 13.9.7
Section 13.9.8(1) (2)
Appendix 1
Appendix 5
: Deletion of parameter No.PA08 name and initial value
: Deletion of "built-in regenerative register" from
excessive regenerative load warning (A.E0) definition
and cause
: Division of Load ratio graph for MR-J3-
B(4) and MR-
J3-CR55K(4)
: Addition of notation "supplied with converter unit" for
7) and 8)
: Addition of Note
: Revision of connection diagram, change of Note 2,
addition of Note 5
: Addition of mass table
: Deletion of notation for UL/C-UL from body paragraph
: Deletion of Note
: Change of body paragraph
: Change of Iga display range in the diagram
: Change of parameter No.PB17 from “for manufacturer
setting” to “Automatic setting parameter”
Change of parameter No.PC06 from “for manufacturer
setting” to “function selection C-3”
: Update of the “combination of servo amplifier and
servo motor” table
(2)Wiring
: Change of description for “the servo motor will operate
improperly” to “the servo motor will not operate
properly” for the item of connection between the servo
amplifier and the servo motor
Conformance with UL/C-UL standard (3): Change of description
Conformance with UL/C-UL standard (5): Deletion of list of combination with fuse
About the wires used for wiring: Addition of the selected standard temperature
Jun, 2008 SH(NA)030051-D
Section 1.2 (1) to (3)
Section 1.3 (1)
Section 1.5 (2)
Section 1.6
Section 1.7.1 (3) (4)
Section 1.8 (3) (4)
Section 2.1 (1) (b)
Section 2.3 (2)
Section 3.1 (5) to (8)
: Change of switch numbers
: Change of description for the mass “2.3” to “2.1”of
MR-J3-200B, Change of pound notation for mass to
three significant digits
: Change of appearance of MR-J3-200B to the same as
MR-J3-200B4
: Addition of models with reduction gear to body
paragraph
: Switch between (3) and (4), Change of the description
for MR-J3-200B to the same as MR-J3-200B4,
Addition of Note 4 to (3).
: Switch between (3) and (4), Change of the description
for MR-J3-200B to the same as MR-J3-200B4,
Addition of Note 4 to (3). Deletion of Note 3 from (4)
Addition of description for FR-BEL to (3)
: Change of description for “Mounting closely is
available for a combination of servo amplifiers of
3.5kW or less in 200V or 100V class.” to “Mounting
closely is available for a combination of servo
amplifiers of 3.5kW or less in 200V or 400W or less in
100V class.”
: Change of description
: Addition of NFB for the fan power cables of the servo
motor’s cooling fan