Polycom 1725-11530-200 Rev A1 Car Speaker User Manual


 
Administrator’s Guide - SoundPoint
®
IP / SoundStation
®
IP Installation and Operation
8 Copyright © 2006 Polycom, Inc.
2.2.1.3 Local User Interface Setup Menus
Access to Network Configuration Menu
Phase 1: bootROM The network configuration menu is accessible during the
auto-boot countdown of the bootROM phase of operation.
Press the
SETUP soft key to launch the main menu.
Phase 2: application The network configuration menu is accessible from the
main menu. Navigate to Menu>Settings>Advanced>Admin
Settings>Network Configuration. Advanced Settings are
locked by default. Enter the administrator password to
unlock. Note that the factory default password is 456.
Phone network configuration parameters may be edited by means of:
• Main menu. Refer to 2.2.1.3.1 Main Menu on page 8.
• DHCP submenu. Refer to 2.2.1.3.2 DHCP Menu on page 9.
• Server submenu. Refer to 2.2.1.3.3 Server Menu on page 11.
• Ethernet submenu. Refer to 2.2.1.3.4 Ethernet Menu on page 12.
Use the soft keys, the arrow keys, the Sel/
3
, and the Del/X keys to make changes.
Certain parameters are read-only due to the value of other parameters. For example, if
the DHCP Client parameter is enabled, the Phone IP Addr and Subnet Mask parame-
ters are dimmed or not visible since these are guaranteed to be supplied by the DHCP
server (mandatory DHCP parameters) and the statically assigned IP address and sub-
net mask will never be used in this configuration.
2.2.1.3.1 Main Menu
Configuration parameters that may be edited on the main setup menu are described in
the table below:
Name Possible Values
a
Description
DHCP Client Enabled, Disabled If enabled, DHCP will be used to obtain the
parameters discussed in 2.2.1.1 DHCP or Man-
ual TCP/IP Setup on page 5.
DHCP Menu Refer to 2.2.1.3.2 DHCP Menu on page 9.
Note: Disabled when DHCP client is disabled.
Phone IP Address dotted-decimal IP
address
Phone’s IP address.
Note: Disabled when DHCP client is enabled.
Subnet Mask dotted-decimal subnet
mask
Phone’s subnet mask.
Note: Disabled when DHCP client is enabled.