Filter
Top Products
6 - 6
6. DISPLAY AND OPERATION
6.5 Parameter mode
The parameters whose abbreviations are marked* are made valid by changing the setting and then
switching power off once and switching it on again. Refer to Section 5.1.2.
(1) Operation example
(a) 4-digit parameter
The following example shows the operation procedure performed after power-on to change the
control mode (parameter No. 0) to the speed control mode.
UP DOWN
Press MODE three times.
⋅⋅⋅⋅⋅⋅⋅⋅
The parameter number is displayed.
Press
or
to change the number.
Press SET twice.
⋅⋅⋅⋅⋅⋅⋅⋅
The set value of the specified parameter number flickers.
Press UP once.
⋅⋅⋅⋅⋅⋅⋅⋅
During flickering, the set value can be changed.
Use
or
.
Press SET to enter.
(2: Speed control mode)
UP DOWN
To shift to the next parameter, press the
UP DOWN
/
button.
When changing the parameter No. 0 setting, change its set value, then switch power off once and switch it
on again to make the new value valid.