Filter
Top Products
13 - 7
13. COMMUNICATION FUNCTIONS
13.5 Error Codes
Error codes are used in the following cases and an error code of single-code length is transmitted.
On receipt of data from the master station, the slave station sends the error code corresponding to that data
to the master station. The error code sent in upper-case indicates that the servo is normal and the one in
lower-case indicates that an alarm occurred.
Error Code
Servo normal Servo alarm
Error Name Description Remarks
[A] [a] Normal operation Data transmitted was processed properly. Positive response
[B] [b] Parity error Parity error occurred in the transmitted data.
[C] [c] Checksum error Checksum error occurred in the transmitted data.
[D] [d] Character error
Character not existing in the specifications was
transmitted.
[E] [e] Command error
Command not existing in the specifications was
transmitted.
[F] [f] Data No. error
Data No. not existing in the specifications was
transmitted.
Negative response
13.6 Checksum
Checksum range
Check
Checksum range
ETXSTX or
SOH
Station number
The check sum is a ASCII hexadecimal representing the lower two digits of the sum of ASCII hexadecimal
numbers up to ETX, with the exception of the first control code (STX or S0H).
S
T
X
02H
[0]
30H
[A]
41H
[1]
31H
[2]
32H
[5]
35H
[F]
46H
E
T
X
[5] [2]
03H
30H + 41H + 31H + 32H + 35H + 46H + 03H
= 152H
(Example)
Lower 2 digits 52 is sent after conversion into ASCII code [5][2].